Red-NTV-25KB Standard Signal Converter
Red-NTV-25KB obsolete. Fully compatible replacement: ▸Drago DN25000.
Benefits
- Galvanic isolation and conversion of unipolar process signals.
- Input and output signals selectable with DIP switch.
- Compact, rugged DIN-rail mountable modules.
Standard Signal Converter
The Standard Signal Converter is used for electrical isolation and conversion of unipolar process signals. The input and output range can be set by using DIP switch and due to the calibrated range selection no further adjustment is necessary. The 3-way isolation guarantees reliable decoupling of the sensor circuit from the processing circuit and prevents linked measurement circuits from influencing each other. The Protective Separation with high isolation level provides protection for personnel and downstream devices against impermissibly high voltage. The auxiliary power can either be supplied via the connection terminals or via the In-Rail-Bus connector.
- Standard signal converter for electrical isolation and conversion of unipolar process signals.
- Input/output range can be set by DIP switch.
- Due to the calibrated range selection no further adjustment is necessary.
- 3-way isolation guarantees reliable decoupling of the sensor circuit from the processing circuit.
- Bandwidth 5 kHz, 100 Hz, 10 Hz.
- Input/output range: 0...20 mA, 4...20 mA, 0...10 V, 2...10 V.
- Power supply: 24 VDC (16.8...31.2 V, approx. 0.8 W).
- Power supply: 24 VDC (16.8...31.2 V, approx. 0.8 W). In-Rail-Bus for power supply.
- Construction: 6.2 mm housing, protection type: IP 20. 35 mm DIN-rail mountable.
Included: Module, instructions for use.
Last seen