Gossen Metrawatt SYSKON Power Supply Series

Benefits of the GMC-I SYSKON Lab Power Supplies, Computer Controlled, PF Corrected

• Rugged 60 V DC power-supplies, 500, 800, 1500, 3000, or 4500 W power.
• Very short setting times (2 ms), very high setting resolution (1 mV, 1 mA, 1 ms).
• Interfaces USB, RS232 (on board) and GPIB (optional) as well as analog interface.

Gossen Metrawatt SYSKON Power Supply Series

The innovative new GMC-I/Gossen Metrawatt SYSKON series of "Konstanters" power supplies provides you with top quality manual and remote controllable DC power supplies for laboratory and system use.

Equipped with active power-factor control (PFC), it supplies 500 til 4500 W of power at up to 60 V and max. 180 A with characteristic UIP curve.

Special switching controller technology and matching status controllers assure high dynamics and short response times. The setting range for output voltage and output current can be restricted by specifying setting limits.

The analog interface is equipped with two programmable trigger inputs and three signal outputs, which can be linked to various device functions for indication, or for controlling external devices and an auxiliary power output. Beyond this, monitor outputs and control inputs for voltage and current setpoints are available as well. Sensing leads allow for auto-sensing operation at the power consumer. Strict menu-driven operation supports highly diverse programming functions. The device is transformed into a freely programmable test signal generator by means of an expanded sequence memory and extra functions.

• Mains power input with power factor control (PFC).
• Highly efficient, low power loss.
• Auto-ranging output with 500, 800, 1500, 3000 and 4500 W of power.
• Output: Voltage and current regulated.
• Characteristic UIP curve.
• Very short response times.
• Excellent dynamic control parameters.
• Minimal residual ripple.
• Output on/off function.
• Comprehensive calibration report.
• Dynamic sink mode operation.
• Lockable controls.
• Master-slave operation for parallel and series connection.
• Sequence functions with sequence control for creating voltage and current sequences.
• Overvoltage, overcurrent and overtemperature protection.
• Calibrating procedure for menu-driven balancing.
• USB and RS 232 interfaces (complete control of the device).
• Floating output terminals on the rear panel.
• Analog interface (extended).
• Dimensions SYSKON P500, P800, P1500:
  Benchtop device WxHxD (mm): 447 x 102 (88 without feet) x 541 (501 without handles),
  19" rack device: 19" x 2 U x 501 mm.
  Dimensions SYSKON P3000, P4500:
  Benchtop device WxHxD (mm): 447 x 102 (88 without feet) x 541 (501 without handles),
  19" rack device: 19" x 4 U x 501 mm.
• Optional:
  IEEE488 interface (with measured value querying).
  Driver software for LabVIEW, LabWindows and Keysight VEE.
  Power line for P3000 and P4500.

Model Overview